In addition to being a decorative element, the shower curtain is also a partition that limits the toilet and shower or bath area. By using this shower curtain, the toilet area is protected from splashing water from the shower, and the floor around it is kept dry. There are many types of shower curtains on offer. However, how do you choose a shower curtain to suit the conditions in the bathroom? Check out the review here.
When choosing a shower curtain, what should be prioritized is the size, style, and type of fabric. The choice of this type of fabric greatly affects the design of your bathroom.
Bath sash materials on the market, in general, are PVC and PEVA materials. Compared to these two materials, the clear peva shower curtain is odorless, more friendly to nature, and has a better taste. Therefore, PEVA material is chosen for a soft sash with good touch and good drape.
The shower curtain fabric is not as thick as possible, a fabric that is too thick will affect the breathability and dryness of the shower curtain. It is also not easy to dry in water. Prolonged use may cause bacteria to form and multiply. In general, the thickness usually produced is 0.1-0. 15 mm
The width of the shower curtain is chosen to be larger than the place where the shower curtain is hung, to ensure that the shower curtain is pulled tightly, and the height of the shower curtain is generally 180-200cm.
Washing
The thing to remember is that the bathroom is an area that has high humidity, and becomes the most mold development. For this reason, the shower curtain must be cleaned regularly, which is about once a month. Before washing, make sure the curtain rings are all removed, and the rings must be cleaned because they are exposed to water and humidity every day. For the ring, you can clean it by wiping it with warm water and detergent.
How to Clean Bathroom Curtains, Use These Simple Steps
Bathroom curtains are usually made of water-resistant materials. But that doesn’t mean it can’t be dirty.
The most common types of shower curtains are made of vinyl, polyester, and Peva.
While these materials are water-resistant, they are prone to dirt and stains that require thorough cleaning to remove.
Here’s how to clean the bathroom curtain as quoted from the Maidforyou page.
- Baking soda
- Liquid laundry detergent
- Household bleach
- Spray bottle
- Brush
- Bucket/tub (big enough to soak the curtains)
- Long rubber gloves
- Protective goggles
How to clean:
- In a plastic spray bottle, mix equal proportions of liquid bleach and water. Put on your rubber gloves and protective eyewear before using the bleach solution. This is because small droplets dispersed into the air during spraying can cause skin and eye irritation. Shake the bottle well, and clean the shower curtain by spraying it from top to bottom as it hangs. Do this on both sides and leave for 15 minutes.
- Fill the tub or bucket with enough water to completely submerge the shower curtain. Using warm water over room temperature water is recommended as the former helps break down tough dirt and removes mold spores on fabrics Add 1-2 tablespoons of liquid detergent to the water and stir to mix the soap well. Place the shower curtain inside and gently massage the fabric with your gloved hands. Repeat this process every few minutes until the curtains are submerged in the solution for at least 15 minutes.
- Remove the curtain from the soap solution, lay it flat on your bathroom floor, and scrub both sides thoroughly with a scrub brush. Pay attention to the seams and edges because this is where mold and dirt tend to hide. If there is a stubborn stain, sprinkle a little baking soda over the area and then scrub the stain and clean it in a circular motion.
- Rinse the tub/bucket and refill with plain water. Dip the entire shower curtain in the water several times to remove soap and other residues. For a thorough rinse, drain the water and repeat steps 2-3 times or until all soap and dirt are gone. To dry your fabric shower curtain, remove any excess water, and hang it back up to dry.